MSI G52-M6570XA-G22 User Manual
Page 79
3-24
MS-6570 ATX Mainboard
IRQs Activity, IRQ3~IRQ15
IRQ3~IRQ15 enable or disable the monitoring of the specified IRQ line.
If set to [Enabled], the activity of the specified IRQ line will prevent the
system from entering power saving modes or awaken it from power saving
modes.
After AC Power Lost
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
Off
Leaves the computer in the power off state.
On
Leaves the computer in the power on state.
Last State
Restores the system to the status before power failure or
interrupt occurred.
MSI Reminds You...
IRQ (Interrupt Request) lines are system resources allocated to I/
O devices. When an I/O device needs to gain attention of the oper-
ating system, it signals this by causing an IRQ to occur. After re-
ceiving the signal, when the operating system is ready, the system
will interrupt itself and perform the service required by the I/O
device.