Preparing and using the remote control, P.17, P.16 – MITSUBISHI ELECTRIC SE1U User Manual

Page 9: Preparations, Operating the remote control, Loading dry-cell batteries into the remote control

Advertising

Preparations

■ Operating the remote

control

Point the remote control toward the
projector’s infrared remote sensor,
and press a button on the remote
control.

• Operating the projector from the front

Approx. 15

Approx. 5m

• Operating the projector from the rear

Approx. 15

Approx. 5m

■ Loading dry-cell batteries

into the remote control

q Remove the battery cover.

w Insert the dry-cell batteries.

Load the batteries making sure that
they are positioned correctly ( + to +,
and - to -). Load the batteries from -
spring side, and make sure to set them
tightly.

Two batteries (R03, SIZE AAA) are
used.

e Replace the battery cover.

Dry-cell batteries

• Before using the batteries, be sure to observe the ABOUT REMOTE BATTERIES

described in previous pages.

• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries with

new ones.

The remote control

• The remote control may fail to operate if the infrared remote sensor is exposed to bright

sunlight or fluorescent lighting.

• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this

happens, point the remote control at the main unit again, and repeat the operation.

Preparing and using the remote control

Names of each part on the control panel and remote control

Control panel

FAN TEMP LAMP POWER

VOL.

(1)

(2)

(3)

(4)

(5)

(6)