Invacare 1900 - Manual (Page 15)

SECTION 2—OPERATING THE BATH LIFT
Part No. 1148113 15 1900/1900S Bath Lift
Removing/Installing the Safety Strap
ƽ WARNING
DO NOT put the safety strap in the dryer. The high heat will melt the belt’s material.
NOTE: For this procedure, refer to FIGURE 2.10.
NOTE: The safety strap MUST be washed and disinfected after each use.
1. Unbuckle the safety strap by pulling up the hook‐and‐loop strip on the buckle.
2. Pull the hook‐and‐loop strip through the buckle (Detail “A”).
3. Remove the safety strap from the chair.
4. Repeat STEPS 1 to 3 for the other side.
5. Wrap the new safety strap around the lift frame.
6. Insert the hook‐and‐loop strip through the buckle and secure it to the chair frame
(Detail “B”).
7. Repeat STEPS 5 and 6 for the other side.
FIGURE 2.10 Removing/Installing the Safety Strap
Installing/Removing the
Shoulder Strap
NOTE: For this procedure, refer to
FIGURE 2.11.
NOTE: To remove the shoulder strap, reverse
this procedure.
1. Insert the belt through the bracket at
the top of the chair.
2. Loop the hook‐and‐loop strip through
the bracket and secure the strap.
FIGURE 2.11 Installing/Removing the
Shoulder Strap
Buckle
Hook-and-Loop Strip
Chair Frame
Safety Strap
Buckle
Hook-and-Loop Strip
Chair Frame
Safety Strap
DETAIL “A”
DETAIL “B”
Shoulder
Strap
Chair
Hook-
and-Loop
Strip