iHome iP90 - Manual (Page 5)

3
Setting Up the iP90
iP90 Display
Alarm Indicators
Battery Low Indicator
Time Display
PM Indicator
AM Indicator
NOTE: AM/PM indicators will not appear
when clock is set to 24 hour display mode
Radio / Alarm Time / iPod Display
Connect iP90 to Power Source
Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 100-240 VAC wall socket. Adaptor must be
plugged in to operate. The iP90 does not operate on batteries.
Using the Hotel Switch
The iP90 has a 3 position switch on the bottom of the unit. For regular home use, keep the switch in Normal position. Hotel Low lowers
the output of the unit and Hotel High maintains regular output. While in either Hotel mode:
a) Clock adjust and 12h/24h buttons are disabled
b) Radio presets can be accessed, but not programmed
c) Alarms operate as single day alarms (will not automatically come on the next day even if Alarm Reset is pressed), 7-5-2 operation
is disabled, and wake to playlist is disabled
d) The remote control sensor is disabled
Setting the Clock Time
Time Display Options
a) Press and hold the 12H/24H Button at any time to toggle between displaying the time in 12 hour (AM and PM) mode or 24 hour
mode
Setting the Clock
a) Slide the ST switch to adjust for Summer Time (+1 for Summer time, -1 for Standard time).
b) Press and hold the Clock Adjust Button located on the back of the unit. The clock display will flash.
c) Press the + or - Button until the current time is displayed.
d) Press the Clock Adjust Button to accept the time. The year display will flash.
e) Press the + or - Button to adjust the year and press the Clock Adjust Button. The date display will flash.
f) Press the + or - Button to adjust the date and press the Clock Adjust Button. Two beeps will indicate clock setting is complete.