InFocus XS1 - Manual (Page 55)

Maintenance 55
11. Restart the projector.
Resetting the lamp timer
12. After the startup logo, open the On-
Screen Display (OSD) menu. Go to the
SYSTEM SETUP: Advanced > Lamp
Settings menu. Press Mode/Enter. The
Lamp Settings page displays. Highlight
Reset Lamp Timer. A warning message
displays asking if you want to reset the
lamp timer. Highlight Reset and press
Mode/Enter. The lamp time will be reset
to '0'.
CAUTION
• Do not reset if the lamp is not new or replaced as
this could cause damage.
7. Tighten the screw that secures the lamp.
CAUTION
• Loose screw may cause a bad connection,
which could result in malfunction.
• Do not over tighten the screw.
8. Ensure the handle is fully laid flat and
locked in place.
9. Replace the lamp cover on the projector.
10. Use a coin to turn the screw clockwise
until the lamp cover is secured.
CAUTION
• Loose screw may cause a bad connection, which
could result in malfunction.
• Do not over tighten the screw.
Reset Lamp Timer?
Reset Cancel
Notice