Troubleshooting guide – Iluv i1166 User Manual

Page 14

Advertising
background image

iLuv | 26

i1166 | V10M10_IM_EN_091509

25 | iLuv

TROUBLESHOOTING GUIDE

No key operation (with the main unit and/or the remote control unit) works

· Press on the remote control to set the player to the standby mode and then switch back on.

· Slide the POWER OFF/ON switch to the OFF position, then set back to ON position.

· Key lock function is activated, slide the HOLD switch to DOWN position to release the key lock

function.

Audio and/or subtitle language are not shown on the disc or not in the setup menu.

· If the audio and/or subtitle language does not exist on the language selected in the setup menu,

it will not be seen or heard.

No subtitles

· Subtitles are not available on all discs.

· Subtitles are cleared from the LCD screen. Perform the steps in the subtitle setup instruction to display

the subtitles.

Alternative audio (or subtitle) language fails to be selected.

· An alternative language will not be selected with discs featuring only one language.

The movie angle cannot be changed.

· This function is contingent on software availability. Even if a disc has a number of angles recorded,

these angles may be recorded for specific scenes only.

TROUBLESHOOTING GUIDE

No Power

· Insert the AC power plug securely into the wall power outlet

iPod isn’t recharged.

· Check whether your iPod is properly installed in the dock.

Play does not begin even after is pressed or it starts to play and stops immediately

· Condensation may have formed. Allow 1 to 2 hours for the player to dry out.

· The disc may be incompatible with this unit. This player can only play DVD, VCD and CD formats.

· The disc may be dirty and require cleaning.

· The disc may be improperly loaded. Be certain it has been loaded with the label side up.

No picture on the LCD screen

· Ensure that the disc or iPod mode is properly set.

· Ensure that the iPod is properly connected.

No sound or distorted sound

· Ensure that the disc or iPod mode is properly set.

· Ensure that the iPod is properly connected.

· Ensure that the input settings for the iPod are properly set.

Picture is distorted during the rapid advance or rapid reverse

· The picture will be somewhat distorted at times. This is normal.

No rapid advance (or rapid reverse) playback

· Some discs may have sections which prohibit the rapid advance (or rapid reverse).

Remote Control Does Not Work

· Ensure that the batteries are installed with the correct polarities (+ and –).

· The batteries may be exhausted. Replace them with new ones.

· Point the remote control unit at the remote control sensor and attempt operation.

· Operate the remote control at a distance of less than 6m from the remote control sensor.

· Remove the obstacles between the remote control unit and remote control sensor.

Advertising
This manual is related to the following products: