Image IMSB63120 - Manual (Page 8)

8
2. Refer to the drawing on page 6 and locate the short
access opening. Next, locate the indicated gate
valves inside the short access opening. Make sure
that the gate valves are open and that the locking
clips are snapped onto the stems of the gate valves,
as shown in the inset drawing.
Make sure that the four collars are tightened.
Refer to step 1 above. Re-attach the Short Access
Panel (2) to the spa with four #10 x 2” Sheet Metal
Screws (7).
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials from the spa shell. Do not dis-
pose of the packing materials until assembly is
completed and the spa is operating.
• During assembly, make sure that all parts are
oriented as shown in the drawings.
• Read each assembly step before you begin.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING
TOOLS (not included):
• One (1) phillips screwdriver
• You may also need a small amount of soapy
water.
A wire connector is provided on the electronics
pack of the spa to connect a minimum No. 6
AWG solid copper conductor between the spa
and any metal equipment, electrical enclosure
made of metal, metal water pipes, or conduit
within five feet of the spa.
1. Before beginning assembly, make sure that you
have read and understand the information in the
box above and on the previous two pages.
Remove the eight #10 x 2” Sheet Metal Screws (7)
from the indicated Access Panels (2, 5). Remove the
Access Panels by sliding them down and then pulling
the bottoms of the Access Panels away from the spa.
Be careful not to damage the spa shell.
If desired, snap the three pillows onto the spa shell.
Each pillow can be attached in either a high position
or a low position. To determine the desired position,
attach a pillow to the spa shell, note its position,
remove it, turn it 180°, and then reattach it.
Assembly
Collars
7
7
5
2
1
Spa Shell
Spa Shell
Pillow
Pillow
Pillow
2
Gate Valve
Gate Valve
Gate Valve
Stem
Locking
Clip