Intellinet Network Solutions GUESTGATETM HOTSPOT GATEWAY 523240 - Manual (Page 3)


• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit than the receiver.
• Consult your dealer or an experienced radio/TV technician for help.
• Check that shielded (STP) network cables are being used with this unit to
ensure compliance with eMC standards.
This equipment has been tested and found to comply with the limits for a Class
B computing device pursuant to Subpart B of Part 15 of FCC rules, which are
designed to provide reasonable protection against such interference when
operated in a commercial environment. operation of this equipment in a
residential area is likely to cause interference, in which case the user, at his
own expense, will be required to take whatever measures may be required to
correct the interference.
This digital equipment fulfills the requirements for radiated emission according
to limit B of eN55022/1998, and the requirements for immunity according to
eN55024/1998 residential, commercial and light industry.
Safety
This equipment complies with eN 60950, Safety of Information Technology
equipment.
Radio Transmission Regulatory Information
This equipment generates and radiates radio frequency energy, and must be
installed and operated while maintaining a minimum distance of 20 cm between
the radiator and your body.
Tested to comply with FCC Standards FoR HoMe oR oFFICe USe.
This product must be installed and used in strict accordance with the instructions
given in the user documentation.
This product complies with the following radio frequency and safety standards:
europe — eU declaration of Conformity. This device complies with the
requirements of the R&TTe directive 1999/5/eC with essential test
suites as per standards eN 301489: General eMC requirements for
radio equipment; and eTS 300328: Technical requirements for radio
equipment.
USA — Federal Communications Commission (FCC): This device complies
with Part 15 of FCC Rules. operation of the device is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may cause undesired
operation.