Image 8.0 - Manual (Page 17)

17
42. Locate the Leg Press Cable (75). Attach the Leg
Press Cable to the indicated side of the Press
Upright (2) with a 3/8” x 3 1/4” Bolt (62) and a 3/8”
Nylon Locknut (50).
Do not tighten the Nylon
Locknut yet.
Wrap the Leg Press Cable (75) up around a 3 1/2”
Pulley (24) in the direction shown. Attach the Pulley
and a Cable Trap (25) to the indicated side of the
Press Frame (8) with a 3/8” x 4 3/4” Bolt (60) and a
3/8” Nylon Locknut (50).
Do not tighten the Nylon
Locknut yet. Be sure that the Cable Trap is
turned to hold the Cable in place.
43. Wrap the Leg Press Cable (75) around a 3 1/2”
Pulley (24) in the direction shown. Attach the Pulley
and a Cable Trap (25) to the indicated side of the
Press Seat Frame (7) with a 3/8” x 4 3/4” Bolt (60)
and a 3/8” Nylon Locknut (50).
Do not tighten the
Nylon Locknut yet. Be sure that the Cable Trap
is turned to hold the Cable in place.
44. Wrap the Leg Press Cable (75) around a 3 1/2”
Pulley (24) in the direction shown. Attach the Pulley
and a Cable Trap (25) to the indicated side of the
Press Leg Lever (90) with a 3/8” x 4 3/4” Bolt (60)
and a 3/8” Nylon Jamnut (63).
Do not tighten the
Nylon Jamnut yet. Be sure that the Cable Trap is
turned to hold the Cable in place.
45. Wrap the Leg Press Cable (75) around a 3 1/2”
Pulley (24). Attach the Pulley and a Cable Trap (25)
to the indicated side of the Press Base (6) with a
3/8” x 5 1/2” Bolt (55) and a 3/8” Nylon Locknut
(50).
Do not tighten the Nylon Locknut yet. Be
sure that the Cable Trap is turned to hold the
Cable in place.
Wrap the Leg Press Cable (75) around another
3 1/2” Pulley (24). Attach the Pulley between the
Small Pulley Plates (22) with a 3/8” x 1 3/4” Bolt
(57) and a 3/8” Nylon Locknut (50).
Be sure the
Leg Press Cable is routed so that it crosses
from one side of the Press Base (6) to the other.
45
42
43
44
62
2
7
25 8
50
75
60
75
50
24
55
22
57
50
25
50
7
24
63
90
75 25
60
24
75
24
60
25
6