Infinity Wireless Router & AP WZR-G300N - Manual (Page 14)

1
This AirStation supports quickly changing the
product from a wireless router to a conventional
access point.
Put your Airstation into Access Point Mode
by moving the switch on the bottom of your
AirStation from AUTO to BRI. This changes
the default IP address of the AirStation from
192.168.11.1 to 192.168.11.100, and DHCP,
NAT, and the WAN port are disabled.
Access Point Mode might be desirable if you’re adding wireless capability to an existing
network with a router, or configuring your AirStation as part of a repeater bridge setup. It
is not suitable for most home configurations. If you plan to use the AirStation as an normal
wireless router, make sure that this switch is in the normal (AUTO) position!
To set up your AirStation as a bridge or repeater, flip the switch to BRI and turn to page
44.
Router/Access Point Mode