InStep 5K - Manual (Page 2)

2
IMPORTANT
Tires are shipped deflated, DO NOT OVERINFLATE. Please inflate slowly, with short bursts, to 20-25 PSI
maximum. 25 PSI will provide a comfortable ride for your child.
We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with
your selection. Great care and effort has been taken, however occasionally problems may occur. PLEASE DO
NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of problems, or to answer
questions, please contact us at either our Toll-Free Customer Service number or E-mail us at our number listed
below. Service will be quicker if you have your model number (found on the product and box) along with this
instruction sheet ready when calling. If you have any questions concerning the safe use of this product,
please contact us 1-800-242-6110 press “1” for customer service and then “2” to speak to a representative
or E-mail us at [email protected] or visit us at www.instep.net.
5K • 10K • 20K ULTRA • Marathon Assembly Instructions
Parts List
Tools Required: Phillips screw drive, adjustable wrench.
Stroller Assembly Instructions
Step 1. Unfold Stroller
Grasp handle with one hand, and pull up on the
front fork with your other hand. Lock both plastic
latches onto the lower frame, insert locking pin into
hole in latch and frame, lock the pin in place by
slipping the wire loop over the end of the lock pin.
On Double Models repeat for other side.
(Figures A1, A2, A3, A4 and A5).
A1
A2 A3 A4
A5
Description Qty.
Frame assembly with seat,
canopy, basket and wrist strap
1
Front Wheel Assembly with Q/R axle 1
Rear Wheel Assembly 2
Description Qty.
Front Fender 1
#8 – 1 1 ⁄ 2 " Phillips head screws 2
(Double Models have 4) ...
Back Rest
Handle
Rear Frame
Latches
Side
Latch
Locking
Pin
Locking
Pin Open
Locking
Pin Closed
Front
Fork