ION RX-V750 - Manual (Page 30)

28
AUTO SETUP
8
Use the cursor buttons to display the results.
• Press u / d to display information about
individual results.
• Press j / i to switch between each result list.
9
When finished, press SELECT.
The RESULT:EXIT screen appears.
10
Press u / d to select SET or CANCEL.
SET To apply the auto setup (YPAO)
settings.
CANCEL To cancel the auto setup (YPAO)
without making any changes.
11
Press SELECT to set or cancel the auto
setup settings.
y
If you are not satisfied with the result or want to manually adjust
each setup parameter, use the manual setup parameters (see
page 55).
• If E-10 appears during testing, restart the procedure from step 3.
• To cancel the auto setup procedure before completion, press
SET MENU.
■ If an error screen appears
1
Press SELECT to display detailed
information about the error.
2
Press j / i to switch between error
messages.
For details about each message, see page 30.
3
When finished, press SELECT to return to
the main error screen.
4
Press u / d to select RETRY or EXIT, then
press SELECT.
RETRY To retry the auto setup procedure.
EXIT To exit auto setup.
Notes
FRONT L ;;;;;;;OK
[<]/[>]:Select
[SELECT]:Return
RESULT:WIRING
RESULT:EXIT
NO WARNING
RESULT LIST
. )SET CANCEL
[ ]/[ ]:Up/Down
[SELECT]:Enter
p
p
ERROR
. E-5:NOISY
)RETRY EXIT
[ ]/[ ]:Up/Down
[SELECT]:Enter
p
p
ERROR: E-5
< NOISY >
Keep SILENT
[SELECT]:Return
ERROR
E-5:NOISY
. )RETRY EXIT
[ ]/[ ]:Up/Down
[SELECT]:Enter
p
p
01EN_00_RXV750_GB.book Page 28 Friday, March 5, 2004 11:40 AM