IBM ILC200 - Manual (Page 31)

Use this setting to select between On and Off. When it is on, most new
computers will automatically recognize the projector and then set the monitor
resolution and refresh rate accordingly. You need to set the Plug and Play
setting to Off for the projector to properly display images from some older
computers. The Plug and Play setting does not affect video images.
If the projector display constantly changes between the computer image and
the message, “Perfecting the image,” you might need to turn Plug and Play
off.
Display messages
Use this setting to select between On and Off. When this feature is on, status
messages such as “No signal detected” or “Standby Active” are displayed in
the lower-right corner of the screen. Click the left or right navigation button to
turn this feature off and suppress status messages.
Display startup screen
Use this setting to select between On and Off. When this feature is on, the
startup screen is displayed when the projector starts, and remains until an
active source is detected. The startup screen contains projector support contact
information. Click the left or right navigation button to turn this feature off
and display a plain black or blue screen instead of the startup screen.
Language menu
The following settings allow you to adjust the language.
You can display the on-screen menus in English, French, German, Spanish,
Chinese, or Japanese. Move the cursor to the language that you want and then
click the left or right navigation button. The menus are redisplayed.
Installation and user’s guide 1-23