IGo Direct Bluetooth Keyboard - Manual (Page 7)

5. Next, type the same Passkey number on
the Stowaway keyboard. When finished,
press the <Enter> key on your keyboard.
6. If the Passkey is entered successfully on
both devices, the message BT Keyboard
Connected will appear. If the keyboard
does not show up as connected:
a. Press the Discoverable button again.
b. Or, power cycle the keyboard (slide
the right panel out and in), then
press Discoverable button.
c. Or, check that the Red LED on the
keyboard is not lit after a power
cycle, indicating a dead battery.
7. If the passkey is not entered correctly, the
connection will fail. In this case you will
need to repeat steps 3-5 from above.
NOTE: Please, make sure that the passkey
is entered on your mobile device first, tap
Done (twice), and then follow with the
passkey on the keyboard. When finished,
press the <Enter> key on the keyboard.
Stowaway Bluetooth Owner’s Manual for Symbian UIQ
Page 7