For your reference, Com port setting, Windows vista – Icom IC-7200 User Manual
Page 14
14
FOR YOUR REFERENCE
COM Port setting
To change the COM Port number setting, connect the transceiver to the PC and then turn the transceiver power ON
after the driver installation is completed.
Windows Vista
q
Start up Windows.
w
Right click “Computer,” then select “Properties.”
• “Computer” is available in <Start> menu.
e
“System” screen appears as below.
Click [Device Manager].
Click
r
In case “User Account Control” dialogue box ap-
pears as below, click [Continue].
Click
t
“Device Manager” screen appears.
Right click “CP210x USB to UART Bridge Controller
(COMM)” and then click “Properties.”
“M” is the COM port number, that is used for the
communication setting with the utility software.
Click
Right-click
y
Click [Port Settings] tab, then click [Advanced...].
Click
Click
u
Set the desired COM port number, then click [OK].
Click
Set
i
Click [OK] to close the screen.
Click
When the transceiver is connected to a PC with the USB cable (third party), remote control operation can be per-
formed with the CI-V command.
The IC-7200 has the USB-Serial convert function, so the PC recognizes the connected transceiver as COM port
and the CI-V control software can be used.
Simultaneous use of the [USB] and [REMOTE] jacks are available.