Intel MD566X - Manual (Page 49)

56K V.92 Data, Fax, and Voice Chipset
Programmer’s Guide Intel Confidential 49
Wn 0
Response Code Data Rate: This command selects whether the modem
sends the DTE independent modem connection result codes for speed, error
control protocol, or data compression.
n = 0** CONNECT result code reports DTE speed.
n = 2 CONNECT result code reports DCE speed.
n = 3 CONNECT result code reports DTE data rate, modulation mode, er-
ror correction, data compression, DCE transmitter speed and DCE
receiver speed when the mode is configured for verbose V1 (text)
response codes. For numeric responses V0, the modem responds
with the W0 numeric response codes. The verbose response codes
use the following format:
CONNECT (DTE data rate) /(modulation)/(error correction)/(data
compression) / TX=(DCE transmit data rate) / RX=(DTE receive
data rate)
Modulation types include: V21, V22, V22B, V23C, V32, V32B, V34,
V.90 and V.92
Error correction types include: NONE, LAPM, MNP
Data compression types include: NONE, V42B, MNP5
For example:
CONNECT 115200/V34/LAPM/V42B/TX=28800/RX=28000
n = 4 CONNECT result code reports DCE protocol, data compression,
and DCE data rate when the mode is configured for verbose V1 (text
response codes). For numeric responses V0, the modem responds
with the W0 numeric response codes. The verbose response codes
use the following format:
(DCE protocol)
(data compression)
(line speed)
Error correction types include: NONE, LAPM, MNP
Data compression types include: NONE, V42B, MNP5
For example:
PROTOCOL: LAPM
COMPRESSION: V42B
CONNECT 33,600
Table 3-4. Data Mode Command Descriptions (Continued)