InFocus IN26 - Manual (Page 4)

4
Turn on projector and source
Connect the power cord to the projector
and to an electrical outlet
The green power light on the projector will turn on.
Turn on the projector
Press power (on the projector or remote).
The power light will start blinking.
Wait for the lamp to warm up
After a few seconds, the power light will stop blinking and stay
on. It can take a minute for the lamp to reach full brightness.
5-10 sec.
1
2
3
Turn on computer or other source
4
Change source if needed
If needed, press source (on the projector or remote) to view the
source. You may have to press it more than once.
5
Warning: Do not look directly into the lens
when the projector is turned on.
You may need to press a specific key combination to activate
your laptop’s external video port. On most laptops, hold down
the Fn key while pressing a key labeled CRT/LCD, LCD/VGA,
a monitor icon , or similar. Key combos for popular models:
Apple F7
Dell Fn+F8
Fujitsu Fn+F10 Gateway Fn+F3 or Fn+F4
HP/Compaq Fn+F4 or Fn+F5
Sony Fn+F7 IBM ThinkPad Fn+F7
Toshiba Fn+F5
Complete laptop activation chart at www.infocus.com/s upport
Important: If there is still no video, restart your
computer (first make sure it’s connected to the
projector and the projector is turned on).
i