IKEA DW60 - Manual (Page 11)

Water hardness Water hardness setting
°dH °TH mmol/l Clarke manually electronically
4 - 10 7 - 18 0,7 - 1,8 5 - 12 1 2
< 4 < 7 < 0,7 < 5 1 1) 1 1)
1) No use of salt required.
You must set the water softener manually
and electronically.
Manual adjustment
The appliance is set at the factory at position
2.
1 2
Set switch to position
1 or 2.
Electronic adjustment
The water softener is set at the factory at
level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold the programme selection/
cancel button.
4. Release the programme selection/cancel
button when programme indicator light A
starts to flash and programme indicator
light B comes on.
5. Wait until programme indicator light B
goes off.
– Programme indicator light A starts to
flash.
– The end indicator light starts to flash.
6. Press the programme selection/cancel
button one time.
– Programme indicator light A starts to
flash.
– The setting function of the water softener
is activated.
– The end indicator light flashes to show
the level of the water softener.
Example: 5 flashes, pause, 5 flashes,
pause, etc... = level 5.
7. Press the programme selection/cancel
button one time to increase the water soft-
ener level by one step.
8. Press the on/off button to save the opera-
tion.
Use of dishwasher salt
Caution! Only use dishwashers salt.
Types of salt that are not applicable for
dishwashers cause damage to the water
softener.
1 2
ENGLISH 11