Invacare CROSSFIRE T6 - Manual (Page 45)

SECTION 8—WHEELS
Part No 1148078 45 Crossfire™Series Wheelchairs
4. Align the desires mounting positions of the camber tube mounting brackets with the
opening of the camber tube supports.
5. Install the four socket screws, washers, and lock washers into the desired mounting
positions of both camber tube mounting brackets. Hand tighten.
6. Slide the camber bar forward or backward to adjust the wheelbase length to the
desired position. Securely tighten the four socket screws.
7. Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 38.
FIGURE 8.8 Repositioning the Camber Tube Mounting Bracket Socket Screws
Reversing the Camber Tube Mounting Bracket Direction
NOTE: For this procedure, refer to FIGURE 8.9 on page 46.
1. Remove the rear wheels
2. Remove the four socket screws, washers, and locking washers that secure the two
camber tube mounting bracket to the camber tube supports.
3. Rotate the camber tube so that the camber tube mounting bracket faces the opposite
direction.
4. Align the desires mounting positions of the camber tube mounting brackets with the
opening of the camber tube supports.
5. Install the four socket screws, washers, and lock washers into the desired mounting
positions of both camber tube mounting brackets. Hand tighten.
6. Slide the camber bar forward or backward to adjust the wheelbase length to the
desired position. Securely tighten the four socket screws.
Socket Screws
Washers
Camber Tube
Support
Camber
Tube
Camber Tube
Mounting Bracket