InFocus DISPLAY LINK IN3104 - Manual (Page 6)

6
7
Using the menus
1
Press menu, then press or to review menus.
2 Press select to enter a menu, then press or to review settings.
3 Press select to change a setting. If this shows more choices, press
or to update the setting, then press select or menu to save it.
4 Press menu to go back. Press it again to remove the menu.
Note: Most picture settings are disabled (gray) unless a source is being displayed.
Controlling your presentations
Connect the USB cable between your computer and the projector's DisplayLink
connector (see step
3
), then press and to move through your presentation slides.
Turn off the projector
Press the power button
The power light on the projector will blink while the fan cools
the lamp. If you need to unplug the projector, wait until the
fan stops and the power light stops blinking and stays on.
Note: While the power light is blinking, button presses on the
projector and remote are ignored.
Register your product
Activate your warranty to ensure eligibility for service and support.
Get special offers and notifications about free product updates.
1
Write down your projector's serial number
It's printed on the label on the back of the projector. You'll need it to register (and if
you ever need to contact support).
Serial number:
2
Go to www.infocus.com/register
Optional: Read the Reference Guide
Download it at www.infocus.com/support
The Reference Guide is available in multiple languages. It covers advanced setup and
operation, including lamp replacement instructions.
Note: You don't need to install DisplayLink Manager software to use this feature.