IBM 6 MPLS - Manual (Page 10)

Specialized Models User Guide 6 MPLS Model User Guide
SPM-6-10 Modeler/Release 10.0
Figure 6-10 Recovery Parameters Configuration
• Setup Parameters—specifies the duration of the LSP.
Figure 6-11 Setup Parameters Configuration
• TE Parameters—specifies the traffic engineering constraints used by
CR-LDP to find a route through the network. CR-LDP uses Constrained
Routing to find the route that is the best fit for the specified constraints. This
attribute applies to dynamic LSPs only. Make sure you account for network
bandwidth availability when configuring static LSPs.
Figure 6-12 TE Parameters Configuration