Ikelite pdf #4104.6 ..... Nikonos TTL Cord Film Camera - Manual (Page 4)

Connecting the Strobe
1. Make sure all components are dry.
2. Clean and lightly lubricate the Stem O-ring and
the housing connector threads. Check the O-ring
for nicks or cuts.
3. Note the positioning of the receptacles and pins.
Properly align the end of the sync cord and insert it
into the strobe connector.
4. Push the connector body into the strobe connector
until it stops.
5. Align and hand tighten the knurled retaining ring.
Limited Warranty
This Ikelite product is warranted against any manufacturing defects for a
period of one (1) year from the original date of purchase. Defective
products should be returned to Ikelite postage paid. Ikelite will, at its sole
discretion, repair or replace such products, and will return to customer
postage paid. All other claims of any nature are not covered. Except as
mentioned above, no other warranty expressed or implied applies to this
Ikelite product.
Ikelite
Connector
Retaining
Ring
Stem
O-ring
Lubricant
Use only Ikelite brand lubricant with Ikelite O-rings. Other brand
lubricants can cause Ikelite O-rings to swell in size. Use only enough
Ikelite lubricant (supplied) to lightly cover the O-ring. Wipe off any
excess with a lint free cloth. The lubricant will reduce friction, but it is
NOT a sealant. DO NOT use spray lubricant as the propellant ingredient
can cause plastic to crack.
Ikelite Underwater Systems
50 West 33rd Street
Indianapolis, IN 46208 USA
4104.6_Ike_Nik_Cord_03 -0712