IFB Appliances ELENA EX - Manual (Page 7)

16 AMPS
X
X
WATER INLET
DRAIN
PIPE
WATER INLET
DRAIN
PIPE
Water Inlet
1. Connect inlet hose to water tap/line.
2. Do not connect machine to a hot water
supply.
Water Outlet
1. A drain pump is provided in the machine to
pump out used water.
2. The end of the outlet should be placed near a
drain. If necessary, it can be placed over the
edge of a sink at a maximum height of 1 mt.
from the floor level.
3. Allow free flow of water from the outlet pipe.
Electrical Connection
q Check that the electrical line take the required
load.
q Connect to a 230V, 50Hz single phase AC
supply. The appliance must be positioned so
that the plug is accessible.
q Machine must be earthed properly before
operation. This can be done by using a 3 - pin
plug and a properly earthed operated socket
of 16 Ampere rating.
q If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard. It should not be stretched
when connected to the main socket.
9
Dimensions(DxWxH) : 56 cm x 60 cm x 85 cm
Weight : 57 kgs
Capacity : 5 Kgs of dry clothes (cotton)*
Programmes : 10 wash care programmes
0 Selector Buttons : On/Off, 60 C.
Spin Speed : 600 rpm
Heater Rating : 1.9 kW
Drum : Stainless Steel
0 Temperature Selection : 60 C
Drain Pump Rating : 30 W
Water Consumption : 75 litres for normal wash.
Power Consumption : 0.25 unit for cold wash
0 Cotton Wash Programme : 0.6 - 0.9unit hot wash at 60 C
Connected Load : 2.35 KW Max.
Programme Duration : 50 to 115 minutes
Power supply : 220 - 240 V, Single Phase, 50 Hz
2 Water Pressure : 1 bar ( 1.03 kg/cm ) - 10 bar ( 10.3
2 kg/cm )
Specifications are subject to change without prior notice.
*Capacity depends on size, texture and combination of clothes
Depending on water pressure, Water hardness, Water inlet
Temperature, Quantity and type of textile, Detergents used, Degree of
soiling, Ambient condition, selected additional functions & power
supply fluctuations the actual values given on or with the machine can
deviate from the declared standard values, as they are tested
according to the laboratory conditions
TECHNICAL DATA
28