InStep ET100 - Manual (Page 3)

3
Step 3. Front Wheel Assembly
Turn stroller upright onto its rear wheels and then
tip stroller back so that the handlebar is down on
the ground and the front fork is up. The front
brake Quick Release lever (Q/R), located on the
front fender, should be in the open position
(Figure C).
Attach the front wheel by loosening the wheel’s
quick release (Q/R) lever on the front wheel far
enough to allow the axle to slide into the front
fork (Figure D). With lever in open position, hand
tighten the cone nut until almost tight, then flip
lever backward to the closed position to lock
wheel in place. Note this step may require minor
adjustment until the Q/R lever flips back with firm
pressure (Figure E). Pull outward on wheel to
ensure it is locked in place.
Close the front caliper brake by lowering the Q/R
lever (Figure F). Spin the front wheel to make
sure the brake pads do not rub and are properly
aligned to the rim. If brake pad alignment is off,
loosen brake pad nut with an adjustable wrench,
align brake pad and retighten nut while holding
the brake pad in place.
WARNING: The interior jam nuts are
factory installed and do not need adjustment.
WARNING: Always be sure to re-engage
the brake by rotating the Q/R lever forward
(toward the front wheel) before using the stroller.
Assembly is now complete!
C
D
E
F
Brake Pad
Nut
Brake Pads
Closed
Open
Q/R Brake
Lever
Q/R Lever
Open
Q/R Lever
Closed
Closed Cone
Nut
Cone
Nut
Front Fork
Adjusting
Sleeve
Lock Ring
Q/R Brake
Lever Closed
Brake Pad Nut