InSciTek Microsystems Allworx Phone - Manual (Page 28)

Phone Guide
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2007 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems. All other names may be
trademarks or registered trademarks of their respective owners.
Revised: March 28, 2007
Page 24
i. Enabled (Default)
ii. Disabled
b. VLAN – Allows the phone to stay on the same network without any hardware reconfiguration.
i. Enabled
ii. Hub Debug Mode (Default)
iii. Disabled
c. Remote Plug ‘n’ Play – Key used to set up a remote phone. See the System Administrator.
d. Edit Time Server IP – Option to change the Time Server the phone is logged into.
e. Edit Boot Server IP – The WAN IP address the server is using for the setup of a remote phone.
f. Edit Phone Server IP – Option will appear if DHCP is disabled. Allows the manual entry of the
phone’s IP.
g. Edit Netmask IP – Option will appear if DHCP is disabled. Allows the manual entry of the
Netmask IP.
h. Edit Gateway IP – Option will appear if DHCP is disabled. Allows the manual entry of the
Gateway IP.
i. Phone VLAN Settings – Option will appear if VLAN is enabled.
i. Enter VLAN ID – 2 (Default)
ii. Enter VLAN Priority – 7 (Default)
j. PC VLAN Settings – Option will appear if VLAN is enabled.
i. Enter VLAN ID – 1 (Default)
ii. Enter VLAN Priority – 0 (Default)
4. Select the EXIT soft key.
5. Select the YES soft key to save any changes OR select NO to cancel changes made.
7.8 Current Status / Info
1. Select the CONFIG soft key.
2. Highlight Current Status/Info.
3. Press the Select button.
4. The following information is listed:
• DHCP Lease Time (if DHCP is enabled)
• SNTP Time Server IP
• Boot Server IP
• Phone IP