Integra DPS-8.3 - Manual (Page 17)

17
MODEL NO. DPS- 8.3
SACD & DVD AUDIO/VIDEO PLAYER
REMOTE
CONTROL
COMPONENT 2
IR
DIGITAL
OUTPUT
OPTICAL COAXIAL
OUT
IN
S VIDEO VIDEO
Y P B P R
COMPONENT 1
VIDEO
OUTPUT
ANALOG
OUTPUT
L
R
L
R
SURR
1 1+2
CH 1 CH 2 FRONT SURR 1 CENTER SURR 2
SUB WOOFER
TRIG-
GER
OUT
RS-232
AC INLET
12 V
Y P B P R
Connecting to an Amplifier (To Enjoy the Sound
Advantage of the DVD Player)
Before connecting
• Refer to the instruction manual of the amplifier.
• When you connect the DVD Player to the amplifier, be sure to turn off
the power and unplug both units from the mains before making any
connections. Otherwise, the speakers may be damaged.
• Connect the plugs securely.
Notes
• The remote controller supplied with Integra/Onkyo amplifier can
be used to operate the DVD player.
• The function of the upper and lower z connectors are the same.
Connect to either one.
• Connecting z cable only does not make the system operational.
You must also connect the audio cables as well.
• When using the optical input jack, remove the protective cap and
keep it safely. When the jack is not used, replace the protective cap.
■ Making a digital connection with the
amplifier
If your amplifier has a digital input jack, be sure to connect
it to either DIGITAL OUTPUT OPTICAL or COAXIAL jack
on the DVD player.
Note
DO NOT connect to the AC-3RF input (e.g. of a Dolby Digital
receiver) which is reserved only for video disc players.
To ensure proper delivery of sound, be sure to match the names
of the jacks on the DVD Player and the component being
connected to.
Although you can reproduce the DVD Player’s sound from the TV speakers with the connections on pages 15 and 16, connecting
with an amplifier provides you high quality dynamic sounds.
: Signal flow
Optical fiber connection cable
To Digital optical jack
Incomplete
Insert completely
Audio connection cables
To audio inputs
Be sure to set the digital output setting after
connection using the Setup Navigator explained in
“Setting Up the Player” starting on page 21 or the
function setting menu explained in “Adjusting
Audio and Video Settings” starting on page 46.
Coaxial cable
To coaxial inputs
An amplifier with a Dolby
Digital/DTS/MPEG1/MPEG2
decoder
DO NOT connect
the mains lead at
this time.
z cable
To z jack
Note
If you listen to multichannel DVD-Audio through one of the digital
outputs, it will be downmixed to stereo. Also, high sampling rate
DVD-Audio (192kHz or 176.4kHz) will be downsampled to 96kHz,
88.2kHz, 48kHz, or 44.1 khz, depending on the disc. Multi channel
and high sampling rate DVD-Audio is only available through the
analog outputs.
Some DVD-Audio and all SACD audio is output only through the
analog outputs.
In order to enjoy Dolby Digital/DTS 5.1 channel sound, a separate
Dolby Digital decoder, and 5.1 channel (front right/left, center,
surround right/left) + subwoofer are required.
L (White)
R (Red)