Image IMBE53991 - Manual (Page 12)

12
19. Lubricate an M10 x 115mm Bolt (55). Slide an M10
Washer (6) onto the Bolt.
Attach the Backrest Adjustment Bracket (36) to the
bracket on the Bench Frame (5) by guiding the M10 x
115mm Bolt (55) through the indicated side of the
Backrest Adjustment Bracket (36), the bracket on the
Bench Frame, and the 15mm x 10.5mm x 56mm
Spacer (57). Next, slide the Bolt through the other
side of the bracket on the Bench Frame, and the
other side of the Backrest Adjustment Bracket.
Secure the Bolt with an M10 Washer (6) and an M10
Nylon Locknut (11).
Do not over tighten the Nylon
Locknut.
19
6
36
57
5
11
6
55
27
20. Lubricate an M10 x 180mm Bolt (22). Attach the
Backrest Tubes (27) to the indicated tube on the
Bench Frame (5) with the Bolt, two M10 Washers (6),
and an M10 Nylon Locknut (11).
Note: Do not over
tighten the Nylon Locknut; the Backrest Tubes
must pivot easily.
20
6
27
11
6
5
22
21. Using four M6 x 55mm Bolts (4) and four M6
Washers (30), attach the Backrest (15) to the
Backrest Tubes (27).
21
30
30
4
15
30
27
4
22. Press a 25mm x 50mm Inner Cap (58) into the open
end of the Seat Support Tube (37).
Lubricate an M8 x 80mm Bolt (63). Attach the Seat
Adjustment Bracket (45) to the indicated side of the
Seat Support Tube (37) with the Bolt and an M8
Nylon Locknut (54).
Note: Do not over tighten the
Nylon Locknut; the Seat Adjustment Bracket must
pivot easily.
22
58 54
63
37
45
Lubricate
Bracket
Lubricate
Tube
Lubricate