Turning off the server, Turning, Server – IBM xSeries 235 User Manual
Page 25
Complete
the
following
steps
to
manually
turn
on
the
server:
1.
Review
the
information
in
2.
Turn
on
all
external
devices,
such
as
the
monitor.
3.
Plug
the
server
power
cords
into
the
power
source.
4.
Press
the
power-control
button
on
the
front
of
the
server.
Note:
While
the
server
is
powering
up,
the
power-on
LED
on
the
front
of
the
server
is
lit.
Turning
off
the
server
Turning
off
the
server
refers
to
the
act
of
disconnecting
the
server
from
the
power
source.
Complete
the
following
steps
to
manually
turn
off
the
server:
1.
Review
the
information
in
2.
See
your
operating
system
documentation
for
the
proper
procedure
to
shut
down
the
operating
system.
Statement
5
CAUTION:
The
power-control
button
on
the
device
and
the
power
switch
on
the
power
supply
do
not
turn
off
the
electrical
current
supplied
to
the
device.
The
device
also
might
have
more
than
one
power
cord.
To
remove
all
electrical
current
from
the
device,
ensure
that
all
power
cords
are
disconnected
from
the
power
source.
1
2
3.
Press
the
power-control
button
on
the
front
of
the
server.
This
will
put
the
server
in
Standby
mode.
Note:
You
might
need
to
press
and
hold
the
power-control
button
for
more
than
4
seconds
to
cause
an
immediate
shutdown
of
the
server
and
to
force
it
into
Standby
mode.
You
can
use
this
feature
if
the
operating
system
stops
functioning.
4.
Disconnect
the
server
from
the
power
source.
Note:
After
disconnecting
all
the
power
cords,
wait
approximately
15
seconds
for
your
system
to
stop
running.
Watch
for
the
power-on
LED
on
the
front
of
the
server
to
stop
flashing.
Chapter
1.
Introducing
the
IBM
xSeries
235
Type
8671
server
13