Ingersoll-Rand 7804 - Manual (Page 3)

80181613_ed3 EN-1
EN
Product Safety Information
Intended Use:
These Drills are designed for driving fasteners and drilling.
For Additional information refer to Air Drills Product Safety Information Manual Form 04580353.
Manuals can be downloaded from www.irtools.com.
Product Specifications
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 16573180 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts
be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
Model Style
Free Speed
Chuck
Capacity
Sound Level
(ANSI S5.1-1971)
Vibration Level
(ISO8662)
rpm in (mm) Pressure
Power
(ISO3744)
m/s 2
7804 Pistol 1800 @ 90 psi 1/4 (6.35) 83.6 94.6 0.3
1. Air filter 7. Coupling
2. Regulator 8. Safety Air Fuse
3. Lubricator 9. Oil
4. Emergency shut-off valve 10. Grease - during assembly
5. Hose diameter 11 Grease - through fitting
6. Thread size