Image IMHS63100 - Manual (Page 8)

8
2. Refer to the drawing on page 6 and locate the pump
access opening. Locate the drain hose inside the
opening. Close the valve knob on top of the drain
hose. Next, make sure that the cap is fully tightened
onto the end of the drain hose.
Locate the four gate valves inside the pump access
opening (there are two gate valves per pump). Make
sure that the gate valves are open and that the lock-
ing clips are snapped onto the stems of the gate
valves, as shown in the inset drawing.
Make sure that the four collars are tightened (there
are two collars per pump).
Refer to step 1 above. Re-attach the pump Access
Panel (2) to the spa with the four 1/4” x 1 1/2”
Machine Screws (7).
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials from the spa shell. Do not dis-
pose of the packing materials until assembly is
completed and the spa is operating.
• During assembly, make sure that all parts are
oriented as shown in the drawings.
• Read each assembly step before you begin.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING
TOOLS (not included):
• One (1) phillips screwdriver
• You may also need a small amount of soap
or water.
A wire connector is provided on the electronics
pack of the spa to connect a minimum No. 8
AWG (8.04 mm
2 ) solid copper conductor
between the spa and any metal equipment,
electrical enclosure made of metal, metal water
pipes, or conduit within five feet of the spa.
1. Before beginning assembly, make sure that you
have read and understand the information in the
box above and on the previous two pages.
Remove the eight 1/4” x 1 1/2” Machine Screws (7)
from the Access Panels (2, 5). Remove the Access
Panels by sliding them down and then pulling the
bottoms of the Access Panels away from the spa. Be
careful not to damage the spa shell.
If desired, snap the three included pillows to the spa
shell at this time. Each pillow can be attached in
either a high position or a low position. To determine
the desired position, attach a pillow to the spa shell,
note its position, remove it, turn it 180°, and then
reattach it.
Assembly
Drain
Hose Valve
Knob
Cap
Collars
7
7
5
2
1
Spa Shell
Spa Shell
Pillow
Pillow
Pillow
2
Gate Valve
Gate
Valve
Gate Valve
Stem
Locking
Clip