Switching on your monitor – IBM L190P User Manual
Page 11
9
DE
UTSCH
EN
GLIS
H
FRAN
ÇAIS
ESP
AÑOL
IT
A
L
IANO
JAP
A
NESE
COMPL &
W
ARR
4.
Connect the DVI connector at the other end of the signal cable to the
DVI port located on the back of the graphics adapter. See picture below.
5.
Connect the power cord to the power port on the back of your monitor if
the power cord supplied is not attached to the monitor. Then insert the
plug into a properly grounded electrical outlet.
6.
Use the cable holder (a) to neatly organize the video and power cables.
7.
Switch on the power source and your computer. To turn on the monitor,
push and release the power switch . To switch it off, push and release
the power switch again.
Switching on your Monitor
1.
Switch on the power source and your computer.
2.
Switch on your monitor by pushing and releasing the power switch
marked .
(To switch off your monitor, push and release the power switch again).
3.
To update or install device drivers, follow the instructions in the Device
Driver Installation section found on page 10.
4.
To optimize the displayed image, run Auto Image Setup by following the
instructions in the Auto Image Setup section found on page14.
DVI
Signal Cable
graphics adapter