Intec AVT-597 - Manual (Page 3)

BEFORE DRILLING ANY HOLES IN THE VEHICLE VERIFY THAT THE DRILL BIT
WILL NOT ENTER INTO THE FRAME RAIL(S) OF THE VEHICLE OR DAMAGE
ELECTRICAL WIRES, FUEL LINES, BRAKE LINES, HOSES, EXHAUST SYSTEM
COMPONENTS OR ANY OTHER ITEMS THAT WILL IMPAIR THE OPERATION
OF THE VEHICLE. THE E-Z FIT FLOOR CONSOLE MUST BE SECURED TO THE
FLOOR PANEL OF THE VEHICLE. CHECK UNDER THE VEHICLE TO ENSURE
THAT THE HOLES WILL BE IN THE PROPER LOCATIONS. ALSO CHECK UNDER
THE CARPET TO ENSURE THAT THERE ARE NO WIRING HARNESSES, FUEL
LINES, ETC. THAT COULD BE DAMAGED WHEN DRILLING THROUGH THE
FLOOR PAN OF THE VEHICLE
CAUTION: BEFORE WORKING UNDER THE VEHICLE BLOCK THE WHEELS TO
PREVENT ACCIDENTAL INJURY.
MOUNTING THE CONSOLE IN A VEHICLE
There are two approved mounting methods for the EZ-Fit floor console. One is permanent, the other is temporary
(i.e., removable).
2
Permanent mounting of the E-Z FIT floor console.
Set the console on the floor of the vehicle and mark where the holes are to be drilled. (Make sure that you have
checked under the vehicle and in the vehicle floor (under the carpet) for obstructions).
Remove the console from the vehicle.
Using the utility knife, score the carpet over the marks with an ‘X’ so that the drill bit does not ‘grab’ and unravel
the carpet.
Drill four small 1/8” pilot holes to verify that the holes are in the proper locations.
After verifying that the 1/8” pilot holes are in the proper locations, use the ¼” drill bit to enlarge the pilot holes.
Set the console on the floor over the holes.
Place the 4 bolts through the brackets of the console and into the holes just drilled.
Place one sealing washer (rubber side towards vehicle floor) and one large fender washer over each of the bolts
and attach the nuts. (Note: In addition to the sealing washer it may be desirable to place a small circle of silicon
sealer around the hole under the vehicle before installing the washers and nut to further prevent moisture from
getting into the vehicle.)
Tighten the nuts down securely. Have the second person inside the vehicle hold the bolts securely with the
box-end wrench while the person underneath the vehicle tightens down the nuts. See Figure 1 below.
Plug the cigarette lighter cord into the jack on the console (by driver’s seat). Plug the other end into the
cigarette lighter receptacle.
Figure 1
BOLT
BRACKET
VEHICLE FLOOR
FENDER WASHER
SEALING WASHER
NUT