InFocus 61md10 - Manual (Page 26)

Connections & Setup
24 Chapter 1
Tip
To access the setup menus, press MENU and
choose Assisted Setup.
Plug in the TV
Plug the flat end of the power cable into the power jack on the side of the TV. Go to page 10 for
instructions on removing the jack panel door. Then plug the other end of the power cord into an
appropriate wall outlet. Be sure to insert the plug completely. Do not plug into an outlet
controlled by a light switch.
Note: When you first plug your TV into an outlet, the Power indicator and Backlight on
the front panel will light and blink for approximately 30 seconds and then go off during
the initialization of the TV. The TV can only be turned on after the Power indicator goes
off. This happens every time the TV is unplugged and plugged back in.
Tip
When remote batteries are low, the component
button(s) corresponding to the mode you’re in
flashes when you press a button. Also, a message
might appear on the TV screen and disappear
within a few seconds. Press CLEAR and replace the
batteries to remove the message.
Put Batteries in the Remote
• Remove the battery compartment cover from the back of the remote
by pushing down on the tab and lifting cover.
• Insert 2 fresh “AA” batteries. Make sure the polarities (+ and -) are
aligned correctly with the polarities inside the remote.
• Replace the cover.
Turn on the TV
Press TV on the remote, or press the Power button on the TV’s front
panel.
Note: Pressing the TV button turns on the TV and puts the remote
into TV mode. “TV mode” means that the buttons on the remote
control operate the TV’s functions.
Use the Remote Control to Complete
the Assisted Setup
The technical term is “Navigation” – how you move through the on-screen
menus. The method is the same throughout the menu screens: highlight
your choice and select it.
To highlight a menu item, put the remote into TV mode by pressing the
TV button then MENU. Press the arrow buttons on the remote to highlight
one of the items listed in the menu. Use the up or down arrow button to
move up or down. Use the right or left arrow button to move right or left.
To select the item that you’ve highlighted, press OK.
Note: Highlighted means that the menu item stands out from
other menu items on the list (appears darker, brighter, or a
different color).
ON-OFF
TV
DVD VCR
AUX AUDIO SATCAB
CH. CTRL CH. CTRL FREEZE PIP PIP SWAP SWAP
CC FAV PRESETS LIGHT LIGHT
CLEAR CLEAR
FORMAT FORMAT INFO INFO
MENU MENU
OK
i
CC CC
CC M M
TV
button
Arrow
buttons
OK button
MENU button