InFocus DISPLAY LINK W3902 - Manual (Page 6)

Turn off the projector
READ THE REFERENCE GUIDE
Download it at www.infocus.com/support
The Reference Guide is available in multiple languages. It covers advanced setup and
operation, including using the projector menus, using the remote to control presentations,
using LAN/network functions, and lamp replacement instructions.
Press the power button
The power light on the projector will blink while the fan cools the
lamp. If you need to unplug the projector, wait until the fan stops and
the power light stops blinking and stays on. Note: While the power
light is blinking, button presses on the projector and remote are
ignored.
Optional: Use LiteBoard wand
The wand works with computer sources only
7
8
Charge the wand’s battery
Connect the USB power adapter to an electrical outlet, then connect a USB cable
between the adapter and the wand. Unplug the cable when the light turns off.
Connect the computer and projector with USB
Connect the other USB cable between your computer and the projector’s DisplayLink
connector (see step ). Note: You don’t need to install DisplayLink software to use
the wand.
Turn on the wand
Press the wand’s tip, or press its L or R button (the light will blink).
Use the wand as a wireless mouse
To move: Point the wand at the screen.
To click: Push the wand’s tip onto the screen, or click the L button.
Avoid shadows!
The wand won’t work if its tip is in a shadow, or if it is pointing at a shadow.
i
3
1
2
3
4
For detailed instructions and troubleshooting,
download the Reference Guide (see below).
Lithium battery caution: The LiteBoard wand lithium battery is only rechargeable, and is not user serviceable or user
replaceable. Always use the included USB cable and power adapter (or your computer) to charge the wand.
USB connector
behind flap