InStep RS100 - Manual (Page 2)

2
IMPORTANT
We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with
your selection. Great care and effort has been taken, however occasionally problems may occur. PLEASE DO
NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of problems, or to answer
questions, please contact us at either our Toll-Free Customer Service Number or Email us at our number list-
ed below. Service will be quicker if you have your model number (found on the product and box) along with
this instruction sheet ready when calling. If you have any questions concerning the safe use of this product,
please contact us 1-800-242-6110 press “1” for customer service and then “2” to speak to a representative or
Email us at [email protected] or visit our web site at www.instep.net.
For Model CS300 Only
Tires are shipped deflated, DO NOT OVERINFLATE. Please inflate slowly, with short bursts, to 20-25 PSI
maximum. 25 PSI will provide a comfortable ride for your child.
Parts List
A
B C1
Description Qty.
Frame Assembly 1
Front Wheel Assembly (Dual wheels) 2
Rear Wheel 2
Rear Axle Assembly 1
Description Qty.
Rear Wheel Kit consists of:
Rear hub/brake cog 2
Rear axle retaining clip 2
Rear axle cap 2
Rear wheel hub cap 2
C2
Stroller Assembly Instructions
Step 1. Unfold Stroller
Release storage latch located on side of stroller (Figure A).
Grasp frame as shown and open until side latches engage
(Figure B).
Step 2. Front Wheel Assembly
Turn stroller on its side. Slide the front wheel assembly onto
one of the front legs. Push until the wheel assembly locks into
place. Repeat for other side (Figure C1). Pull firmly on each
wheel assembly to ensure that they are securely attached.
Note: to remove front wheels, press the tab located beneath
wheel assembly (Figure C2).
Storage Latch
Side Latch
Front Leg
Swivel Lock
Wheel
Release
Tab
Front Dual Wheel