Impex PHC-700 - Manual (Page 5)

ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Right and Left Upright Beams (#1 & 2) by a Cross Brace (#3) in the mid-
span. Align the holes and secure each end with one Bracket (#17), two M10 x 2 ¾”
Carriage Bolts (#37), two
∅
¾” Washers (#45), and two M10 Aircraft Nuts (#43).
B.) Place Backrest Adjustment Bar (#5) between the two Upright Beams on the selected
bar holder to obtain desired incline of Backrest Board.
C.) Insert two Crutches (#4) into the top openings on the Upright Beams. Secure them with
two M18 Lock Knobs (#30) through selected holes to obtain desired height of the
Supports.
DIAGRAM 1
4