Intermec F4 - Manual (Page 66)

Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 3 65
Appendix 2 Media Specifi cations
Media Roll Size
Core
Diameters: 38-40 mm (1.5 inches) or 76.2 mm (3 inches)
Width: Must not protrude outside the media
The media must be wound up on the core in such a way that the
printer can pull the end free.
Roll
Max. diameter:
- Position 1 152 mm (6.00 inches)
- Position 2 213 mm (8.38 inches)
- Position 3 213 mm (8.38 inches)
Max. width: 114.3 mm (4.50 inches)
Min. width (standard): 25 mm (1.00 inches)
Min. width (Quick-Load): 40/80 mm (1.57/3.15 inches)
Max. media thickness: 175 µm (0.007 inches)
The maximum recommended media thickness is 175µm. A thicker
media may be used, but print quality will be reduced. The stiffness
is also important and must be balanced against thickness to maintain
print quality.
Media rolls to be loaded inside the printer should be wound with the
printable side facing outwards.
The media supply must not be exposed to dust, sand, grit, etc. Any
hard particles, however small, can damage the printhead.