Integra DPS-6.5 - Manual (Page 54)

54
Using the Remote controller with Other Brand’s
TVs
Learning a pre-programming code
You can make RC-583DV remote controller to operate a
TV from other brand than Integra by storing the pre-pro-
gramming code of the brand in the RC-583DV.
Notes:
• With some brand’s components, some buttons may not
work correctly.
• If more than one code is given in the table, try the code
one by one until you reach the code for your compo-
nent (i.e. if the first code does not work, then try the
next).
• The code can be retained by changing the batteries
within 1 minute. If the code is lost, store the pre-pro-
gramming code again.
Controlling a TV
1 Find the 3-digit number for the
brand name of the component that
you want to operate in the table on
page 55.
2 Turn on the TV that you want to
operate.
3 While holding down the On/
Standby on the RC-583DV that you
want to program, press Enter, and
then release both buttons.
(Make sure you press On/Standby before
Enter.)
4 Within 10 seconds, enter the 3-
digit code number.
On Standby
Open/
Close
Play Mode
Display
1 2 3
4 5 6
7 8 9
0 Clear
Dimmer
Top Menu Menu
Return Setup
Audio Angle Subtitle Zoom
Stop Play Pause
Down Up
T V Control
T V/ Video Channel
On/
Standby
Volume
RC - 583DV
Enter
Enter
On/
Standby
/ / /
TV Control
Numbers
On/
Standby
Enter
1 2 3
6 4 5
7 8 9
0
5 Press some operation buttons for
the component that you want to
operate to check if the system
operates properly.
If the system operates properly, the code
is correct. If the component does not
operate properly, return to step 2.
1 Press On/Standby to turn on the
device.
2 Press the desired operation but-
ton.
+ : Changes the TV channel upward.
– : Changes the TV channel down-
ward.
: Increases the TV volume.
: Decrease the TV volume.
Tv/Video :
Switches the TV/VCR inputs.
On/
Standby
Channel
Volume
T V/Video
DPS-6.5.book Page 54 Thursday, August 5, 2004 3:27 PM