iSimple PGHNI2 - Manual (Page 15)

13
HD Radio Operation
Important Configuration Process
To ensure proper functionality of your HD tuner, you must first set the “TUNE” and
“SEEK” buttons to the proper configuration. (Note: You do not have to repeat this
process if you have already done so for iPod control!) To do this you must first enter the
Mode Select Menu. Press the “RADIO” button a few times until “SAT” is displayed on
the screen. Immediately press the “SCAN” button until “TUNEREV” is displayed. After
6 seconds the radio will time out and the “TUNE” button is now configured properly. You
must repeat the same process for the “SEEK” button. To do this you must first enter the
Mode Select Menu. Press the “RADIO” button a few times until “SAT” is displayed on
the screen. Immediately press the “SCAN” button until “SEEKREV” is displayed. After
6 seconds the radio will time out and the “SEEK” button is now configured properly.
Entering Mode Select Menu
Press the “RADIO” button a few times until “SAT” is displayed on the screen. Immediately
press the “SEEK>>” button to scroll through the available sources. Once “HD-FM” is
displayed, press the “<<TUNE” button to select it.
Tune Up
Press the “TUNE>>” button TWICE to manually tune up.
Seek Up
Press the “SEEK>>” button to seek up to next available station.
Tune Down
Press the “<<TUNE” button TWICE to manually tune down.
Seek Down
Press the “<<SEEK” button to seek down to next available station.
Changing Bands
Press the “AM/FM/SAT” button a few times until “SAT” is displayed on the screen.
Immediately press the “SEEK>>” button to scroll through the available sources.
Once the band you would like to select is displayed (“HD-AM” or “HD-FM”), press the
“<<TUNE” button to select it.
Store Presets
Tune to a station you want to store. Press the “SCAN” button. Press “SEEK>>” to
select the preset location (1-18) where you wish to store the preset. When the preset
location is displayed (for example PRE1) press “<<TUNE” button TWICE to store it.
The screen will display “PR SAVED” and your preset has been stored into memory.
Recall Presets
Press the “SCAN” button. Press “SEEK>>” to scroll through the stored preset stations.
When the desired preset is displayed, press the “TUNE>>” button TWICE to select it.