Insignia NS-LCD26-09 - Manual (Page 15)

13
Insignia NS-LCD26-09 26" LCDTV
www.insignia-products.com
Appendix
Wall-mount hardware (sold separately) lets you
mount your TV on a wall.
For detailed information on mounting your TV on
a wall, see the instructions provided with the
wall-mount hardware.
Contact a technician for assistance when
installing the wall-mount bracket. Best Buy is not
responsible for any damage to your TV or injury
to yourself or others.
We suggest that you keep your TV at least
2.36 inches (60 mm) from the wall to prevent
cable interference.
Before you wall-mount your TV, you need to
remove the base.
To attach a wall mount bracket to your TV:
1 Remove the four M4 screws holding your TV
to the stand.
2 Remove the four screws from the bottom of
the base.
3 Secure the wall mount bracket to the back of
your TV using three M4 screws, as indicated
in the illustration in Step 1.
Specifications
Design and specifications are subject to change
without notice.
“Ghost” or double image • This may be caused by
obstructions to the antenna,
such as high-rise buildings or
hills. Using a highly directional
antenna may improve the
picture quality.
Picture has a few bright
or dark dots • A few bright or dark dots on an
LCD screen is normal. It does
not affect the operation of this
TV.
Remote control does not
work • Press TV.
• Replace the batteries. Make
sure that the + and – symbols
on the batteries align with the +
and – symbols in the battery
compartment.
• Clean the remote sensor on the
front of your TV.
• Bright or fluorescent lighting
may interfere with the remote
control signal. Turn off the light
or move your TV.
Snowy picture or noise • Make sure that the A/V and
antenna cables are connected
correctly and securely.
VGA picture is not stable
or synchronized • Make sure that you have
selected the correct VGA mode
on your computer.
No output from one of
the speakers • Adjust the balance in the Sound
menu.
Control buttons do not
work • Unplug the power cord, wait a
few seconds, then plug the cord
back in and turn on your TV.
After images appear • Do not display a still image,
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent after
image to be burned into the
screen. This type of damage is
not covered by your warranty.
Symptom Possible solution
Analog standard NTSC
Digital standard ATSC, 8-VSB, Clear-QAM
Screen 26-inch
Channel
coverage VHF: 2-13
UHF: 14-69
CATV: Mid band - A-8 ~ A-1, A ~ I
Super band - J ~ W
Hyper band - AA ~ ZZ, AAA, BBB
Ultra band - 65 ~ 94, 100 ~ 135
Power source AC 100~240 V 50/60 Hz
Power
consumption <120 W
<1 W in standby mode
Audio power 5 W + 5 W internal speaker
S-Video input Y:1 V(p-p), 75 ohm, negative sync
C:0.286 V(p-p) (burst signal), 75 ohm
Video/audio
input Video:1 V(p-p), 75 ohm, negative sync
Audio:500 mV(rms)
Remove stand
Remove M4 screws
M4 screws
100 mm
200 mm
Attach wall
bracket here