IBM R/S Rheometer M/02-212 - Manual (Page 41)

Brookfield Engineering Labs., Inc. Page 41 M/02-212
Saving of the Program:
If you push key now, the Program will be saved. If you push any other key, the entries are
abandoned and previous parameters remain (the current ones, before the edit).
VI.6.3 Utilities → Print Programs
This function prints the parameters of defined programs in memory at the printer. Be sure that printer is
connected to the Rheometer and ready for operation.
In the case, the printer is not ready for operation at launching “Print Programs” function, the error
message will be indicated:
In case, this error message appears, please ensure, that the printer is ready and its sheet feeder
contains paper.
Press key to try printing again or push key to return back to the Menue.
VI.6.4 Utilities → Measuring systems
With this function you can create new measuring system or change already defined measuring systems.
Measuring systems are represented by following values. This values might be edited:
• Name of measuring system
• Shear rate factor Kγ [min/s] (k_gamma)
• Shear stress factor τ‰ [Pa] (tau_prom)
Only authorized personnel is permitted to change constants of the measuring
system!
After starting the function you will be prompted to select the measuring system you want to edit. Select
the list item “NEW” to generate a new measuring system.
(2) TEST
Press <OK> to save
ERROR #1
Printer not ready!
<OK> cont. <ST> stop
Select Meas. system:
3) CC45 >
4) CC25
5) CC14 >
ST OK
OK