IBM N2800e - Manual (Page 59)

Installing the power supply:
1. Carefully install the power supply into the logic
unit so that the power supply fan assembly faces
the front of the logic unit.
2. Slide the power supply toward the back of the logic
unit until it stops.
3. Make sure that the power supply is seated correctly,
and firmly into the logic unit.
4. Secure the power supply with the three Phillips
head screws
A removed during the power supply
removal procedure.
5. Slide the support plate
B into place between the
riser card and power supply.
6. Secure the support plate with the two Phillips head
screws
C removed during the power supply
removal procedure.
7. Install the power connector
D into its socket on
the logic board.
8. See “Reassembling the thin client” on page 45.
Appendix B. Hardware maintenance procedures 49