IOGear GBE201 User Manual
Page 17
Advertising
To pair the IOGEAR Bluetooth headset with your Bluetooth phone,
follow the procedure below:
1.
Make sure that the IOGEAR Bluetooth headset is OFF.
2.
Press and hold the multi-function button for about nine (9)
seconds; the red LED will turn ON and the blue LED will start
rapidly flashing; the headset is now in pairing mode.
NOTE: If only the blue LED is on, the headset is in stand-by mode; repeat the
step again and make sure the red LED is on and blue LED is blinking. The
Bluetooth headset will remain in pairing mode for approximately five minutes.
If no pairing takes place during that time interval, it will switch to stand-by
mode.
Pairing to Bluetooth Phone
13
Advertising