Intel 1300 - Manual (Page 16)

16
To assign a static IP address
1. After booting, the appliance displays the Set IP Address menu with blank
octets. Enter an IP address for the appliance by selecting a number for
each zero in each octet:
000.000.000.000 x
2. For each zero in each octet, use the up button to change the value from 0
to 1, 2, 3, and so on. All numbers must be entered using three digits. For
values less than 100, this will require at least one padding zero. As an
example, 5 would be entered as "005" while 79 would look like "079." You
can't set an octet outside the maximum value (255) or the minimum value
(000).
3. To move the cursor from one zero to another zero, use the right or left
buttons. If the cursor is in the square space, pushing the down button
advances you to the next screen.
To assign a subnet mask
1. After entering an IP address, advance to the Set Network Mask menu.
Enter the subnet mask by selecting a number for each zero in each octet:
000.000.000.000 x
2. For each zero in each octet, use the up button to change the value from 0
to 1, 2, 3, and so on. You can't set an octet outside the maximum value
(255) or the minimum value (000).
3. To move the cursor from one zero to another zero, use the right or left
buttons. If the cursor is in the square space, pushing the down button
advances you to the next screen, while the up button moves you to the
previous screen.