IMC Networks McPc-Gigabit - Manual (Page 4)

1
About the McPC-Gigabit
The McPC-Gigabit is a low-cost, IEEE 802.3 single-conversion, PC Card media
converter that converts 1000Base-TX twisted pair to 1000Base-SX multi-mode or
1000Base-LX single-mode fiber. The McPC-Gigabit is available with one RJ-45
connector for the twisted pair port and a SC connector for the fiber port.
The McPC-Gigabit is also available for single-strand which allows two individual
channels to share one strand of fiber; Full-Duplex data travels on different
wavelengths— 1310 nm and 1550 nm.
The McPC-Gigabit can be mounted into any PC with a standard PCI and includes
diagnostic LEDs for each port.
Installing the McPC-Gigabit
Offering plug-and-play operation, the McPC-Gigabit comes ready to install, utilizing
power from the PC’s motherboard. To install the McPC-Gigabit:
1. Turn off the PC
2. Remove its cover
3. Find an empty PCI slot
4. Align the McPC-Gigabit in the slot
5. Screw the McPC-Gigabit into the computer casing’s bracket
6. Make sure the McPC-Gigabit does not extend past the edge of the case
7. Attach the keyed mini-power connector to the McPC-Gigabit
8. Attach the male end of the “Y” connector to one of the computer’s standard size
power connectors
9. Replace the cover
10. Attach the cables between the McPC-Gigabit and the devices that will be
connected
AutoCross
Whether you are using crossover or straight-through CAT5 twisted pair cabling,
McPC-Gigabit will support both types of connections with AutoCross, a feature which
automatically selects between a crossover workstation or Pass-Through connection
depending on the connected device.
FX TX