Icom IC F121S - Manual (Page 49)

5 - 1
SECTION 5 ADJUSTMENT PROCEDURES
+ Audio generator
300 Hz to 3 kHz
AC
millivoltmeter
MICE
MIC
PTT
PTT switch
PTTE
Add a jumper wire here
• *OPC-1122 (JIG CABLE)
Electrolytic
capacitor
47
µF
OPC-1122
(Cloning cable)
5-1 PREPARATION
When you adjust the contents on pages 5-5 and 5-6, SOFT-
WARE ADJUSTMENT, the optional CS-F100S ADJ
ADJUST-
MENT SOFTWARE (Rev. 1.0 or later), *OPC-1122 JIG CABLE
(modified OPC-1122 CLONING CABLE ; see illustration below)
are required.
■ SYSTEM REQUIREMENTS
• IBM PC compatible computer with an RS -232C serial port
(38400 bps or faster).
• Microsoft Windows 95/98 or Windows ME
• Intel Pentium 100 MHz processor or faster
• At least 16 MB RAM and 10 MB of hard disk space
• 640
×480 pixel display (800×600 pixel display recommend-
ed)
■ ADJUSTMENT SOFTWARE INSTALLATION
q Boot up Windows.
- Quit all applications when Windows is running.
w Insert the ‘CS-F100S’ into the appropriate CD drive.
e Select ‘Run’ from the [Start] menu.
r Type the setup program name using the full path name,
then push [Enter] key.
(ex. D:\CSF100SADJ\Setup.exe)
t Follow the prompts.
y Program group ‘CS-F100S ADJ’ appears in the
‘Programs’ folder of the [Start] menu.
■ STARTING SOFTWARE ADJUSTMENT
q Connect IC-F210S and PC with *OPC-1122
JIG CABLE .
w Turn the transceiver power ON.
e Boot up Windows, and click the program group ‘CS-
F100S ADJ’ in the ‘Programs’ folder of the [Start] menu,
then CS-F100S ADJ’s window appears.
r Click ‘Connect’ on the CS-F100’s window, then appears
IC-F210S’s up-to-date condition.
t Set or modify adjustment data as desired.
IBM is a registered trademark of International Bussiness
Machines Corporation in the U.S.A. and other countries.
Microsoft and Windows are registered trademarks of
Microsoft Corporation in the U.S.A. and other countries.
Screen shots produced with permission from Microsoft
Corporation. All other products or brands are registered
trademarks or trademarks of their respective holders.