I-Data ReRouter - Manual (Page 60)

Testing Connection to Remote Device
ida ReRouter
60
PING function succeeded:
If the PING is OK, you receive a system response like this:
PING 192.0.5.7: 56 data bytes
64 bytes from 192.0.5.7: icmp_seq=0.
time=0. ms
64 bytes from 192.0.5.7: icmp_seq=1.
time=0. ms
64 bytes from 192.0.5.7: icmp_seq=2.
time=0. ms
64 bytes from 192.0.5.7: icmp_seq=3.
time=0. ms
64 bytes from 192.0.5.7: icmp_seq=4.
time=0. ms
----- 192.0.5.7 PING Statistics ----------
4. Press CTRL-BREAK to end the PING process and receive the
followng message:
5 packets transmitted, 5 packets received, 0% packet loss
round-trip (ms) min/avg/max 0 / 0 / 0.
PING function failed:
If the PING function failed to provide the expected system response, you
should check the remote device as follows:
1. Make sure that power light on the remote device is ON and that the
LAN light is ON (solid, not blinking). This means that the unit is
connected to the LAN.
2. Press the TEST key on the remote printer device. A test page is
generated on the printer.
NOTE: When you press the TEST key, you make a disconnection
between the printer and the ida ReRouter. To restart, you simply
send another job to this device.
If you need further instructions on how to PING the remote device, you
are referred to the relevant TCP/IP documentation for the host you are
using.