Indesit KG6044WV/G - Manual (Page 3)

3
Installation instructions
The model of appliance are indicated on the rating plate
on the plinth and is visible when drawer is fully pulled out
of runner. The serial number of the cooker is printed on
the rating plate.
1) The cooker can be positioned against the side walls of
other kitchen furniture. However, if the side walls of
the adjacent cabinets don’t withstand up to 60°C
temperature rise, a minimum gap of 10 mm (3/8") must
be left between the sides and the back of the cooker
and the adjacent cabinets for the circulation of air. The
wall behind the cooker must be of flameproof material
and withstand up to 80°C temperature rise. The cooker
is covered by degree of protection X. The height
of furniture installed next to the cook must not
exceed that of the work top.
Caution: INDESIT are unable to accept any responsibility
for failure to comply with the above instructions for
cooker installation.
Cable connection to the cooker
To get access to the terminal board remove cover “D”
using a screwdriver.
D
B
The electrical connection must be done in accordance
with following diagram:
230-240 V ~
L
N
E
Cable H05RRF - 3 x 2,5 mm 2
Yellow - Green
Brown
Bleu
Connection to an electricity supply
These appliances must be instalIed by a competent
electrician with all electrical connections in accordance
with the Regulations for the Electrical Equipm nt of
Buildings, published by the Institution of Electrical
Engineers. A Double-Pole switch must be provided no
further than 2 metres from the appliance to control the
electrical supply. This product must be earthed and fused
in accordance with current rating of the appliance. Before
fitting please ensure that voltage indicated on the rating
plate corresponds to the mains voltage in your home. The
supply to which the cooker is connected should be equal
to or higher than the power absorbed by the cooker. The
rating plate provides information on Model Number, voltage
rating and frequency of this appliance.
WARNING: This appliance must be earthed
Cable connection to the cooker
The earth screw is located at the back of the cooker near
the terminal board. See above diagram.
Important: INDESIT are not liable for any loss or
damage caused by the non observance of the above
instructions.
IMPORTANT NOTE - It is important when inserting the
cable wires (E, L, N) into the relevant slots on the mains
terminal block, to ensure the bared wire is cramped
between the brass plates of the block, as shown in
the diagrams.
screw
plates
bared
wire
CORRECT
screw
plates
bared
wire
INCORRECT