iSymphony M110 - Manual (Page 10)

17 18
When the AC power is connected, “AM 12:00” will appear on the display.
The clock can only be set while the unit is off.
Setting the Clock
Note: This unit uses 12 hour time format only.
Press the PROG/CLK button to confirm.
Press the PROG/CLK button, the “AM” and hour digits begin to flash.
Press the SKIP/TUNING or buttons to adjust the hour.
Press the PROG/CLK button to confirm. The minute digits begin to flash.
Press the SKIP/TUNING or buttons to adjust the minute.
ECO Function
You can select whether or not the clock is displayed while the unit is in standby mode. Selecting
ECO mode means the unit will use less electrical power while in standby mode.
To turn the clock display off:
Hold the SLEEP/ECO button for 3 seconds while the unit is in standby
mode. Display shows “ECO ON” and clock display disappears.
To turn the clock display on:
Hold the SLEEP/ECO button for 3 seconds while the unit is in stand
by mode. Display shows “ECO OFF” and clock display appears.
RADIO OPERATION
Press the FUNCTION button repeatedly until the main display shows “TUNER”.
AM or FM frequency will appear on the display.
Tune to the desired station as follows:
Manual Tuning
Repeatedly press the SKIP/TUNING or buttons until the display shows the exact
frequency of the desired station. Use the Manual Tuning method to tune to weak or distant
stations that are not strong enough to be recognized by the Automatic Tuning system.
Automatic Tuning
Depress and hold the SKIP/TUNING or buttons until the display begins to move, then
release the buttons. The Tuner will search up or down the band for the next strong signal and
stop on that station. Repeat this procedure until the tuner stops on your desired station.
FM Stereo signal is indicated by the “ST” indicator.
Press the STOP/BAND button to switch between the AM and FM bands.
Press the ST/MONO button on the remote control to select FM
Mono mode.
If the FM Stereo reception is noisy or weak: