Invacare 9780E - Manual (Page 4)

Part No 1130174 4 IVC™Heavy Duty Shower Chair
2. Position the backrest into the slot on the seat (FIGURE 3).
3. Push down on the backrest until it sits securely into the seat slot.
4. Check under the seat to ensure the compression tabs on the backrest protrude
beyond the seat slot. If they are visible, the backrest is attached properly. If they
are not, push the backrest further into the seat slot. Refer to Detail “A” of
FIGURE 3.
5. Before using, pull upward on the backrest to ensure the backrest is securely
attached and locked into place.
Removing
1. Locate the compression tabs underneath the seat.
2. Depress both compression tabs with one hand.
3. Using the other hand, hold the backrest handle and pull up and away from the
seat.
4. Release the compression tabs to avoid pinching and continue pulling the
backrest up until it is removed from the seat.
FIGURE 3 Installing/Removing the Backrest
Cleaning
NOTE: Before using any cleaning prodcuts, test an area on the underside of the seat for any
discoloration or staining.
1. Use water and a mild soap or non-abrasive cleanser to clean the shower chair.
Backrest
Backrest Handle
Compression
Tab
Slot in Seat
for Backrest
Seat
Compression
Tab
Detail “A” - Compression tab in
locked position
Compression
Tab
Backrest in
Installed
Position
Seat